RAM vehicles run RF Hub with Fobik and proximity keys. That matters, because it decides whether a key can be added through the diagnostic port in minutes or whether the immobiliser module has to be read directly before a new key will ever be accepted. RAM work trucks and ProMaster vans are handled at your yard or job site, including fleet key duplication with all fobs matched to one vehicle list.

Every RAM job starts the same way: we confirm the exact year, model and key type, verify ownership, then originate the key from the vehicle. The mechanical blade is cut by code from the VIN on a computerised machine — not copied from a worn key — so the new key turns smoothly in the ignition and the door instead of chewing the wafers further. If you still have a working key we can add a spare without disturbing the keys you already own; if every key is gone, we can also erase the lost ones from the vehicle so they can never start it again. That last step matters in New York, where a stolen key is a stolen car.

We carry virgin OEM-grade RAM fobs, shells, batteries and blades on the van, along with Autel, Xhorse and AVDI programming equipment and a Condor code-cutting machine. Typical timing: Spare key 30 min · all keys lost 60–120 min. Beyond keys, we repair the mechanical side that goes with them — sticking ignition cylinders, failed door lock barrels, trunk and glovebox locks — and we can rework cylinders so a single key runs the entire vehicle again.